Mazda 6 Service Manual: Sunroof switch removal/installation
Note
- The sunroof switch is together with the map light.
1. Disconnect the negative battery cable.
2. Remove the map light from the headliner.
3. Install in the reverse order of removal.
Sunroof relay inspection
Note
Sunroof relay is built in the sunroof motor.
1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
2. Connect the sunroof switch connector.
3. Measure the voltage at the sunroof ...
Sunroof switch inspection
1. Remove the sunroof switch.
2. Inspect for continuity between the sunroof switch terminals using an
ohmmeter.
If not as specified, replace the sunroof switch.
...
Other materials:
Mazda 6 Service Manual: Rear door garnish installation
Note
Double-sided adhesive tape has already been attached to the new
rear door garnish.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
1. When installing a new rear door garnish, follow the procedure below:
(1) Remove the adhesi ...
Mazda 6 Service Manual: Front outer handle removal/installation
1. Remove the front door glass.
2. Detach the outer handle and front door latch rod.
3. For protector-equipped vehicles, refer to key cylinder
removal/installation to remove the protector.
4. Remove the bolts.
5. With the rear side of the outer handle fixed and the outer handle lever
pulle ...