Mazda 6 Service Manual: Sunroof unit disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the deflector.
3. Remove the glass panel.
4. Disassemble in the order indicated in the table.
5. Assemble in the reverse order of disassembly.
Slider Disassembly Note
1. Remove the screw.
2. Slide the slider rearward, and remove it from the sunroof frame.
Guide Disassembly Note
Slide the guide rearward, and remove it from the sunroof frame.
Decoration Link Assembly Note
Set the pin in the decoration link.
Guide Assembly Note
1. Move the guide by hand until it comes to the front stopper.
2. Move the guide by hand until center of pin comes between mark A and B.
Sunroof unit removal/installation
1. Disconnect the negative battery cable.
2. Remove the headliner.
3. Remove the glass panel.
4. Disconnect the front and rear drain hose from the sunroof frame.
5. Remove the bolt A, and then rem ...
Sunroof motor removal
1. Disconnect the negative battery cable.
2. Remove the headliner.
3. Disconnect the connector.
4. Remove the screws, and then remove the sunroof motor.
...
Other materials:
Mazda 6 Service Manual: Recommendations for Shifting
Upshifting
For normal acceleration and cruising, Mazda recommends these shift points:
*1 Always observe local speed limit regulations.
Downshifting
When you must slow down in heavy traffic or on a steep upgrade, downshift before
the engine starts to overwork. This gives better acceleration w ...
Mazda 6 Service Manual: Magnetic clutch disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT.)
Bolt Removal/Installation Note
1. When removing or installing the bolt, hold the pressure plate in place as
shown ...