Mazda 6 Service Manual: Tcs (dsc) off switch inspection
1. Remove the TCS OFF switch.
2. Inspect for continuity between the TCS OFF switch terminals using an ohmmeter.
- If not within the specification, replace the TCS OFF switch.
Tcs (dsc) off switch removal/installation
1. Press the hooks of the TCS OFF switch and pull the switch out.
2. Disconnect the connector.
3. Install in the reverse order of removal. ...
Front abs wheel-speed sensor removal/installation
1. Remove the mud guard.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
...
Other materials:
Mazda 6 Service Manual: Dsc system inspection
Preparation
1. Verify that the battery is fully charged.
2. With ignition switch on, verify that the ABS warning light goes out after
2.4 seconds.
3. Turn the ignition switch off.
4. On level ground, jack up the vehicle and support it evenly on safety
stands.
5. Shift the transaxle to N posi ...
Mazda 6 Service Manual: Emergency Locking Mode
When the seat belt is fastened, it will always be in the emergency locking mode. In the emergency locking mode, the belt remains comfortable on the occupant and the retractor will lock in position during a collision.
If the belt is locked and cannot be pulled out, retract the belt once, and then ...