Mazda 6 manuals

Mazda 6 Service Manual: Technical data

Mazda 6 Service Manual / Technical data

ENGINE


LUBRICATION SYSTEM

Note


Recommended engine oil


COOLING SYSTEM


FUEL AND EMISSION CONTROL SYSTEMS


ENGINE ELECTRICAL SYSTEM


*1 : Back-up current is the constant flow of current present (for the audio unit, clock, PCM, etc.) when the ignition switch is off and with the ignition key removed.

*2 : Must not be 0 A.

*3 : Turn the following electrical loads on and verify that the voltage reading increases.

- Headlights, blower motor, and rear window defroster

*4 : Intensely hot area

CLUTCH


MANUAL TRANSAXLE


AUTOMATIC TRANSAXLE



FRONT AND REAR AXLE


STEERING SYSTEM


* : When reservoir tank is at maximum volume

BRAKING SYSTEM


SUSPENSION


*1 : Fuel tank full. Engine coolant and engine oil are at specified level. Spare tire, jack, and tools are in designated position. Adjust to the median when carrying out wheel alignment.

*2 : Difference between left and right must not exceed 1° 30′.

*3 : Distance between wheel center and fender brim is following. Front: 402 mm {15.8 in} (reference value) Rear: 392 mm {15.4 in} (reference value)

Wheel and Tires


*1 : Total weight exceeds 160 g {5.65 oz}.

*2 : One balance weight: 60 g {2.12 oz} max. If the total weight exceeds 100 g {3.53 oz} on one side, rebalance after moving the tire around on the rim. Do not use 3 or more balance weights.

BODY ELECTRICAL SYSTEM


HEATER AND AIR CONDITIONER SYSTEMS


No.9 noise while operating a/c system
Diagnostic procedure * : If there is gas leakage, air enters into the A/C system. The desiccant within the receiver/drier absorbs the moisture from the air and becomes saturated. If the A/C ...

Special tools
ENGINE Ford SST numbers are collated with Mazda SST numbers in the example below. Ford SSTs are marked with Ford SST number. Example 1: Mazda SST number 2: Ford SST number LUBRICATION SYSTEM ...

Other materials:

Mazda 6 Service Manual: Cruise control switch inspection
1. Disconnect the negative battery cable. 2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.) 3. Disconnect the cruise control switch connector. 4. Inspect for resistance and continuity between the cruise control switch terminals using an ohmmeter. ...

Mazda 6 Service Manual: Fuel injector removal/installation
Caution Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it ...

© 2016-2024 Copyright www.mazda6info.net