THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
5. Remove the washer tank.
6. Remove the P/S oil pump.
Note
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
9. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
10. Inspect the engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION.)
THERMOSTAT INSPECTION
Inspect the thermostat for the following.
- If not as specified, replace the thermostat.
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm removal/installation
Caution
When replacing the ABS (ABS/TCS) HU/CM, configuration procedure
must be done before removing the ABS (ABS/TCS) HU/CM. If configuration is
not completed before removing the ABS (ABS/TCS) HU/CM, TCS will not work
properly (with TCS model).
Do not drop the ABS (ABS/TCS) HU/CM. Re ...
Mazda 6 Service Manual: Antilock Brake System (ABS)
The ABS control unit continuously monitors the speed of each wheel. If one wheel
is about to lock up, the ABS responds by automatically releasing and reapplying
that wheel's brake.
The driver will feel a slight vibration in the brake pedal and may hear a chattering
noise from the brake system ...