Note
Resistance Inspection
1. Perform the following test only when directed.
- Accelerator cable free play (See ACCELERATOR CABLE INSPECTION/ADJUSTMENT.)
2. Disconnect the TP sensor connector.
3. Verify that the resistance between TP sensor terminals A and B changes smoothly while opened and closed the throttle valve slowly.
4. Measure the resistance between TP sensor terminals A and C using an ohmmeter.
Specification
3.2-4.8 kilohms
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harnesses for open or short. (Continuity check)
Open circuit
- TP sensor terminal A (harness-side) and PCM terminal 2H (harness-side)
- TP sensor terminal B (harness-side) and PCM terminal 2A (harness-side)
- TP sensor terminal C (harness-side) and PCM terminal 2K (harness-side)
Short circuit
- TP sensor terminal C (harness-side) and power supply
- TP sensor terminal C (harness-side) and body GND
- TP sensor terminal B (harness-side) and power supply
- TP sensor terminal B (harness-side) and body GND
- TP sensor terminal A (harness-side) and power supply
Mazda 6 Service Manual: Rear door trim removal/installation
1. Disconnect the negative battery cable if equipped with power window
system.
2. Remove the regulator handle if equipped.
3. Open the cap using a small screwdriver, then remove the screw.
4. Remove the inner handle cover.
5. Remove the cover, then remove screw.
6. Disengage clips A from th ...
Mazda 6 Service Manual: Trunk Lid
WARNING
Never allow a person to ride in the trunk: Allowing a person to ride
in the trunk is dangerous. The person in the trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the trunk lid open: Exhaust gas in the cabin of a vehicle
is dangerous. ...