Mazda 6 manuals

Mazda 6 Owners Manual: Tire Pressure Monitoring System

Mazda 6 Owners Manual / When Driving / Tire Pressure Monitoring System

The Tire Pressure Monitoring System (TPMS) monitors the air pressure of all four tires. If the air pressure of one or more tires is too low, the system warns the driver by indicating the tire pressure monitoring system warning light in the instrument cluster and operating a beep sound. The system monitors the tire pressures indirectly using the data sent from the ABS wheel speed sensors.

To allow the system to operate correctly, the system needs to be initialized with the specified tire pressure (value on the tire pressure label). Follow the procedure and perform the initialization.

Refer to Tire Pressure Monitoring System Initialization.

The warning light flashes when the system has a malfunction.

Refer to Warning Indication/Warning Lights.


CAUTION

NOTE

Because this system detects slight changes in tire conditions, the timing of the warning may be faster or slower in the following cases:

To Deactivate
When a cruising speed has been set (cruise set indication (green) turns on) Long-press the OFF/CANCEL switch or press the OFF/CANCEL switch 2 times. When a cruising speed has not been set (cruise ma ...

Tire Pressure Monitoring System Initialization
In the following cases, system initialization must be performed so that the system operates normally. A tire pressure is adjusted. Tire rotation is performed. A tire or wheel is replaced. ...

Other materials:

Mazda 6 Owners Manual: Headlight cleaner nozzle removal/installation
1. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION) 2. Disconnect the headlight cleaner hose. (See HEADLIGHT CLEANER HOSE REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 5. Adjust the headlight cleaner nozzle. ...

Mazda 6 Owners Manual: No.1 while vehicle is in reverse, vehicle locator mark goes forward
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiri ...

© 2016-2024 Copyright www.mazda6info.net