Caution
Note
1. Remove the transmitter cover.
2. Apply the circuit tester leads to the positions as indicated in the figure.
3. While pressing the battery as shown in the figure, press the LOCK and UNLOCK buttons on the transmitter at the same time to start measurement of the voltage.
4. Release the buttons after 5 seconds.
5. Verify that the minimum voltage is the standard voltage or more for 10 seconds
after starting measurement.
Standard voltage
2.7 V
Mazda 6 Service Manual: Idle air control (iac) valve inspection
Note
Perform the following inspection only when directed.
Operation Test
Carry out the Idle Air Control Inspection. (See Idle Air Control System
Inspection.)
If not as specified, perform the further inspection for the IAC valve.
Resistance Inspection
1. Disconnect the negative batt ...
Mazda 6 Service Manual: System Operation
Make sure that the Lane-keep Assist System (LAS) & Lane Departure Warning System
(LDWS) OFF indicator light in the instrument cluster is turned off. When the Lane-keep
Assist System (LAS) & Lane Departure Warning System (LDWS) OFF indicator light is
turned on, press the switch and make ...