Mazda 6 Service Manual: Trunk end trim removal/installation
4SD
1. Remove the fasteners.
2. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks.
3. Remove the trunk end trim.
4. Install in the reverse order of removal.
5HB
1. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks.
2. Remove the trunk end trim.
3. Install in the reverse order of removal.
Trunk lid trim removal/installation
1. Pull the handle toward you, then remove the handle.
2. Remove the fasteners, then remove the trunk lid trim.
3. Install in the reverse order of removal. ...
Liftgate upper trim removal/installation
1. Pull the liftgate upper trim toward you, then disengage clips A, and pin B
from the body.
2. Remove the liftgate upper trim.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Closing the Hood
1. Check under the hood area to make certain all filler caps are in place and
all loose items (e.g. tools, oil containers, etc.) have been removed.
2. Lift the hood, grasp the padded area on the support rod, and secure the support
rod in the clip. Verify that the support rod is secured in the c ...
Mazda 6 Service Manual: Engine control system operation inspection
Main Relay Operation Inspection
Verify that the main relay clicks when the ignition switch is turned to ON
position and off.
If there is no operation sound, inspect the following.
- Main relay (See RELAY INSPECTION.)
- Harness and connector between ignition switch and main relay termi ...