Mazda 6 Service Manual: Trunk lid adjustment
1. Measure the gap and height between the front door and the body.
2. If not as specified, loosen the door hinge installation bolts or the door lock striker installation screws, and reposition the door.
Clearance
a: 2.5-4.5 mm {0.10-0.18 in} b: -1.0-1.0 mm {-0.04-0.04 in} c: 4.0-8.0 mm {0.16-0.31 in}
3. Tighten the bolts or screws.
Trunk lid disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the trunk lid trim.
3. To remove the trunk lid outer handle and trunk lid key cylinder, remove
the rear finisher.
4. Disassemble in the order i ...
Stay damper disposal
Note
The gas in the stay damper is colorless, odorless, and non-toxic.
1. Wear protective eye wear.
2. Lay the stay damper flat.
3. Saw through the stay damper body using a hacksaw.
4. All ...
Other materials:
Mazda 6 Service Manual: Installation of radio system
If a radio system is installed improperly or if a high-powered type is used,
the CIS and other systems may be affected. When the vehicle is to be equipped
with a radio, observe the following precautions:
Install the antenna at the farthest point from control modules.
Install the antenna fe ...
Mazda 6 Service Manual: Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)
Follow Schedule 1 if the vehicle is operated mainly where none of the following
conditions (severe driving conditions) apply.
Repeated short-distance driving
Driving in dusty conditions
Driving with extended use of brakes
Driving in areas where salt or other corrosive materials are used
...