Mazda 6 Service Manual: Vacuum hose check valve inspection (power brake unit)
1. Remove the clamps and vacuum hose.
2. Apply both suction and pressure to the engine-side hose, and verify that air blows only toward that side.
- If air flows in both directions or not at all, replace the vacuum hose.
Air bleeding
Caution
Maintain the fluid level in the reservoir tank properly while
bleeding the air.
Specified fluid
Note
The brakes should be bled whenever a brake line is disconnected.
If a h ...
Brake pedal inspection
Brake Pedal Height Inspection
Verify that the distance from the carpet to the center of the upper surface
of the pedal pad is as specified.
Pedal height (reference value)
Brake Pedal Height Adj ...
Other materials:
Mazda 6 Service Manual: Fuel Gauge (Without Multiinformation Display)
The fuel gauge shows approximately how much fuel is remaining in the tank when
the ignition is switched ON. We recommend keeping the tank over 1/4 full.
If the low fuel warning light illuminates or the fuel level is very low, refuel
as soon as possible.
Refer to Warning Lights.
NOTE
...
Mazda 6 Service Manual: After repair procedure
Warning
Fuel line spills and leakage are dangerous. Fuel can ignite and
cause serious injuries or death and damage. When installing the fuel hose,
observe Fuel Leakage Inspection described below.
Fuel Leakage Inspection
Warning
Fuel line spills and leakage are dangerous. Fuel can i ...