Mazda 6 Service Manual: Variable air duct (vad) check valve (one-way) inspection (l3)
1. Remove the VAD check valve (one-way). (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION)
2. Blow through A and verify that air flows from B.
3. Blow through B and verify that air does not flow from A.
- If not as specified, replace the VAD check valve (one-way).
Variable air duct (vad) control solenoid valve inspection (l3)
1. Remove the VAD control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VAD ...
Idle air control (iac) valve inspection
Note
Perform the following inspection only when directed.
Operation Test
Carry out the Idle Air Control Inspection. (See Idle Air Control System
Inspection.)
If not as specified, perform ...
Other materials:
Mazda 6 Service Manual: Cell Phones
WARNING
Please comply with the legal regulations concerning the use of communication
equipment in vehicles in your country: Use of any electrical devices such
as cell phones, computers, portable radios, vehicle navigation or other devices
by the driver while the vehicle is moving is dangerous ...
Mazda 6 Service Manual: Front shock absorber and spring removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-sensor (axle side) and fix it to an appropriate pl ...