1. Remove the VIS control solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harness for open or short (continuity check).
Open circuit
- VIS control solenoid valve terminal A (harness-side) and PCM terminal 4R
- VIS control solenoid valve terminal B (harness-side) and main relay terminal C (harness-side)
Short circuit
- VIS control solenoid valve terminal A (harness-side) and body GND
- VIS control solenoid valve terminal B (harness-side) and power supply
Mazda 6 Service Manual: Vehicle Loading
WARNING
Do not tow a trailer with this vehicle: Towing a trailer with this
vehicle is dangerous because it has not been designed to tow a trailer and doing
so will affect the drive system which could result in vehicle damage.
This section will guide you in the proper loading of your vehicle, t ...
Mazda 6 Service Manual: Spare Tire
Your Mazda has a temporary spare tire. The temporary spare tire is lighter and
smaller than a conventional tire, and is designed only for emergency use and should
be used only for VERY short periods. Temporary spare tires should NEVER be used
for long drives or extended periods.
WARNING
Do n ...