1. Remove the variable tumble control solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harness for open or short (continuity check).
Open circuit
- Variable tumble control solenoid valve terminal B (harness-side) and PCM terminal 4T
- Variable tumble control solenoid valve terminal A (harness-side) and main relay terminal C (harness-side)
Short circuit
- Variable tumble control solenoid valve terminal B (harness-side) and body GND
- Variable tumble control solenoid valve terminal A (harness-side) and power supply
Mazda 6 Service Manual: Seat warmer switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the brake boots panel. (See CONSOLE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Seat Warmer Switch Removal Note
Squeeze the tabs of seat warmer switch and pull it forwar ...
Mazda 6 Service Manual: Trip Computer and INFO Switch (Without Multi-information Display)
The following information can be selected by pressing the INFO switch with the
ignition switched ON.
Distance-to-empty mode
Average fuel economy mode
Current fuel economy mode
Compass mode
If you have any problems with your trip computer, consult an Authorized Mazda
Dealer.
Distanc ...