Without ABS
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner compornent. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
4. Disconnect the vehicle speedometer sensor connector.
5. Remove the vehicle speedometer sensor.
6. Apply transmission oil to a new O-ring and install it on a vehicle speedometer sensor.
7. Install the vehicle speedometer sensor.
Tightening torque 7.8-11.3 N·m
{80-115 kgf·cm, 57.6-83.3 in·lbf}
8. Connect the vehicle speedometer sensor connector.
9. Install the air cleaner compornent. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
10. Install the battery and battery tray.
11. Connect the negative battery cable.
Mazda 6 Service Manual: Fuel-filler lid and opener removal/installation
1. To remove the fuel-filler lid opener, remove the left side trunk side trim
(4SD) or trunk side lower trim (5HB).
2. To remove the fuel-filler lid opener cable, perform the following and turn
over the floor covering.
(1) Remove the driver-side front seat.
(2) Remove the driver-side fron ...
Mazda 6 Service Manual: Abs (abs/tcs) on-board diagnosis
On-Board Diagnostic (OBD) Test Description
The OBD test inspects the integrity and function of the ABS (ABS/TCS)
and outputs the results when requested by the specific tests.
On-board diagnostic test also:
- Provides a quick inspection of the ABS (ABS/TCS) usually performed at
the ...