1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) (See ENGINE COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the drive belt. (See DRIVE BELT REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
7. Inspect the engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION.)
Mazda 6 Service Manual: Shroud panel removal/installation
1. Remove the bonnet. (See BONNET REMOVAL/INSTALLATION.)
2. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
3. Remove the front combination light. (See FRONT COMBINATION LIGHT
REMOVAL/INSTALLATION.)
4. Remove the front bumper reinforcement. (See BUMPER REINFORCEMENT
REMOVAL/ ...
Mazda 6 Service Manual: Precaution
Vehicles with ABS/TCS
1. The ABS warning light, BRAKE system warning light, TCS indicator light
and/or TCS OFF light illuminate even when the system is normal.
*1 : In cases where the light may illuminate, only when ABS/TCS HU/CM detects
that speed sensor of rear wheel is malfunctioning.
*2 ...