Mazda 6 Service Manual: Wheel hub, hub spindle pre-inspection
Wheel Bearing Play Inspection
1. Position a dial indicator against the wheel hub.
2. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play.
Maximum wheel bearing play 0.05 mm {0.002 in}
3. If the bearing play exceeds the specification, replace and tighten the locknut to the specified torque and retest.
- Replace the wheel hub component as necessary.
Rear axle
...
Wheel hub, hub spindle removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing ...
Other materials:
Mazda 6 Service Manual: Woofer removal/installation
4SD
1. Disconnect the negative battery cable.
2. Remove the rear package trim.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5HB
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the rev ...
Mazda 6 Service Manual: Wheel alignment pre-inspection
1. Inspect the tire inflation, and adjust to the recommended pressure as
necessary.
2. Inspect the front wheel bearing play and correct it if necessary. (See
Wheel Bearing Play Inspection.)
3. Inspect the wheel and tire runouts. (See SUSPENSION.)
4. Inspect the ball joints and steering linkag ...