Mazda 6 Service Manual: Clutch master cylinder disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Snap Ring Disassembly/Assembly Note
Hold the piston down using a cloth-wrapped pin punch.
- If disassembling, remove the snap ring; if assembling, install it.
Clutch master cylinder removal/installation
1. Remove the battery and battry tray. (European (L.H.D.), GCC. specs.)
2. Remove in the order indicated in the table.
3. Plug the clutch pipe after removing it to avoid leakage.
4. Install in the ...
Other materials:
Mazda 6 Service Manual: Filament repair
1. Use isopropyl alcohol to clean around the damaged section of the filament.
2. Attach tape above and below the damaged section of the filament.
3. Using a small brush or marking pen, repair the filament with silver paint
or equivalent.
4. After 2-3 minutes, carefully remove the tape without ...
Mazda 6 Service Manual: Generator inspection
Generator Warning Light
1. Verify that the battery is fully charged.
Charge if necessary.
2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT
INSPECTION.)
If not as specified, replace the drive belt.
3. Turn the ignition switch to ON and verify that the gene ...