Mazda 6 manuals

Mazda 6 Service Manual: Dtc 37


Diagnostic procedure


Dtc 35
Diagnostic procedure ...

Inspection of dtcs for condition detection mode
Note The cruise set indicator light will illuminate for 3 seconds, when condition detection mode is on. If the RESUME/ACCEL switch on the cruise control switch is malfunctioning, the cruis ...

Other materials:

Mazda 6 Service Manual: Rear coil spring removal/installation
1. Remove the rear auto leveling sensor. (See REAR AUTO LEVELING SENSOR REMOVAL/INSTALLATION.) 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET.) 5. Inspect the rear wheel alignment. (See REAR WHE ...

Mazda 6 Service Manual: Barometric pressure (baro) sensor inspection
Note Perform the following inspection only when directed. The following vacuum values are indicated by relative pressure from the barometric pressure sensor. 1. Connect the SSTs (WDS or equivalent) to the DLC-2. 2. Turn the ignition switch to ON. 3. Select BARO on the SSTs (WDS or equi ...

© 2016-2026 Copyright www.mazda6info.net