Mazda 6 Service Manual: Dtc c1145, c1155, c1165, c1175
Caution
- When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used.
Diagnostic procedure
Dtc c1140
Diagnostic procedure
...
Dtc c1148, c1158, c1168, c1178, c1233, c1234, c1235, c1236
Diagnostic procedure
...
Other materials:
Mazda 6 Service Manual: Inspection of dtcs for condition detection mode
Note
The cruise set indicator light will illuminate for 3 seconds,
when condition detection mode is on.
If the RESUME/ACCEL switch on the cruise control switch is
malfunctioning, the cruise set indicator light will not give a correct
indication when you inspect the system.
1. Drive ...
Mazda 6 Service Manual: Variable air duct (vad) control solenoid valve inspection (l3)
1. Remove the VAD control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VAD control solenoid valve.
If as specified, carry out the Circuit Open/Short Inspection.
Circ ...