Mazda 6 Service Manual: Dtc p0138

Dtc p0134

Dtc p0140

Other materials:

Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2. 2. Set up the WDS (including the vehicle recognition.) 3. Select Module programming. 4. Select Programmable module installation. 5. Select PCM and perform procedures according to directions on the WDS screen. Note If PCM CONFIGURATION is successful, the PCM ...

Mazda 6 Service Manual: Front lower arm (rear) removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.) 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.) Front Lower Arm (Rear) Ball Joint Removal N ...