Mazda 6 Service Manual: Dtc p0171

Dtc p0140

Dtc p0172

Other materials:

Mazda 6 Service Manual: Oil control valve (ocv) inspection
L3 Coil Resistance Inspection 1. Disconnect the negative battery cable. 2. Disconnect the oil control valve connector. 3. Measure the resistance between terminals A and B using an ohmmeter. If not as specified, replace the oil control valve. Specification 6.9-7.9 ohms 4. Connect ...

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...