Mazda 6 Service Manual: Dtc p0500

Dtc p0480

Dtc p0505

Other materials:

Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over. 2. Disengage clips A using a fastener remover. 3. Pull the A-pillar trim, then disengage clip B (1). 4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar trim (2). 5. Pull clip B out, then rotate 45°. 6. Remove clip B from the grommet b ...

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...