Mazda 6 manuals

Mazda 6 Service Manual: Dtc table

DTC table




After repair procedure
1. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 2. Turn the ignition key from OFF to ON. 3. Record DTC if retrieved. 4. Erase all diagnostic d ...

Dtc p0010
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Rear bumper removal/installation
1. Disconnect the negative battery cable. 2. Remove the rear combination light. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Bumper Removal Note Pull the rear bumper ends (wheel arch) outward to disengage with the bumper slider. Cautio ...

Mazda 6 Service Manual: Operating Tips
Operate the climate control system with the engine running. To prevent the battery from being discharged, do not leave the fan control dial/switch on for a long period of time with the ignition switched ON when the engine is not running. Clear all obstructions such as leaves, snow and i ...

© 2016-2026 Copyright www.mazda6info.net