Mazda 6 manuals

Mazda 6 Service Manual: Dual proportioning valve replacement (without abs)

Mazda 6 Service Manual / Braking system / Conventional brake system / Dual proportioning valve replacement (without abs)

1. Remove in the order indicated in the table.



2. Install in the reverse order of removal.

Dual Proportioning Valve Installation Note

Install the dual proportioning valve so that the R mark faces the left side of the vehicle.


Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure. 2. Bleed the air from the brake system. 3. Measure the fluid pressure of the master cylinder and the rear brake. If not within th ...

Front brake (disc) inspection
Brake Judder Repair Hint Description Brake judder concern has the following 3 characteristics: Steering wheel vibration Steering wheel vibrates in the direction of its rotation. This characteristi ...

Other materials:

Mazda 6 Service Manual: Power steering pressure (psp) switchinspection
Note Perform the following inspection only when directed. Continuity Inspection 1. Inspect the following if the power steering is inoperative (See POWER STEERING FLUID INSPECTION.): Power steering fluid level Power steering fluid leakage Power steering fluid pressure 2. Disconne ...

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

© 2016-2026 Copyright www.mazda6info.net