Mazda 6 Service Manual: Emission system
- Charcoal canister inspection
- Evaporative gas check valve (one-way) inspection (l.h.d.)
- Purge solenoid valve removal/installation
- Purge solenoid valve inspection
- Egr valve removal/installation
- Egr valve inspection
- Pcv valve inspection
- Three-way catalytic converter (twc) inspection
Exhaust system
EXHAUST SYSTEM INSPECTION
Start the engine and inspect each exhaust system component for exhaust gas
leakage.
If leakage is found, repair or replace as necessary.
EXHAUST SYSTEM REMOVAL/INST ...
Charcoal canister inspection
1. Remove the charcoal canister.
2. Plug the atmosphere side port and purge solenoid valve side port of the
charcoal canister.
3. Blow air into the charcoal canister from the fuel tank side port a ...
Other materials:
Mazda 6 Service Manual: Tire house trim removal/installation
4SD
1. Remove the rear scuff plate.
2. Remove the rear seat side.
3. Remove the fastener.
4. Pull the tire house trim upward, then disengage clips A from the body, and
remove the tire house trim.
5. Install in the reverse order of removal.
5HB
1. Remove the rear scuff plate.
2. Pull the ...
Mazda 6 Service Manual: Variable air duct (vad) control solenoid valve inspection (l3)
1. Remove the VAD control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VAD control solenoid valve.
If as specified, carry out the Circuit Open/Short Inspection.
Circ ...