Mazda 6 Service Manual: Identification number locations
VEHICLE IDENTIFICATION NUMBER(VIN)
ENGINE IDENTIFICATION NUMBER
Towing hooks
Caution
The towing hooks should be used only in an emergency (to get the
vehicle out of a ditch or a snow bank, for example).
When using the towing hooks, always pull the cable or chain in a ...
New standards
Following is a comparison of the previous standard and the new standard.
#1 : Diagnostic trouble codes depend on the diagnostic test mode
#2 : Controlled by the PCM
#3 : In some models, th ...
Other materials:
Mazda 6 Service Manual: Dsc hu/cm removal/installation
Caution
When replacing the DSC HU/CM, configuration procedure must be done
before removing the DSC HU/CM. If configuration is not completed before
removing the DSC HU/CM, DTC B2477 will be detected.
Do not drop the DSC HU/CM. Replace it if it is subjected to an
impact.
1. Configura ...
Mazda 6 Service Manual: Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove the A-pillar trim. (See A-PIL ...