Mazda 6 Service Manual: Cruise actuator inspection
1. Disconnect the cruise actuator connector.
2. Measure the voltage, continuity and resistance at the cruise actuator terminals as indicated below.
- If not as specified, inspect the parts listed under Action.
- If the parts and wiring harnesses are okay but the system still does not work properly, replace the cruise actuator.
Terminal Voltage Table (Reference)
Cruise actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Cover Removal Note
Unclamp the clips of the heater hoses at ...
Actuator cable removal
1. Remove the plug hole plate.
2. Remove the cover from the cruise actuator. (See CRUISE ACTUATOR
REMOVAL/INSTALLATION.)
3. Remove the installation nut and pull the cruise actuator toward you.
4. ...
Other materials:
Mazda 6 Service Manual: Outside Mirrors
WARNING
Be sure to look over your shoulder before changing lanes: Changing
lanes without taking into account the actual distance of the vehicle in the convex
mirror is dangerous. You could have a serious accident. What you see in the convex
mirror is closer than it appears.
Mirror type
Flat ...
Mazda 6 Service Manual: Essential Information
Introduction
Be careful not to hurt yourself when inspecting your vehicle, replacing a tire,
or doing some kind of maintenance such as car washing.
In particular, wear thick work gloves such as cotton gloves when touching areas
that are difficult to see while inspecting or working on your vehi ...