Note
Operation Test
Carry out the Idle Air Control Inspection. (See Idle Air Control System Inspection.)
Resistance Inspection
1. Disconnect the negative battery cable.
2. Disconnect the IAC valve connector.
3. Measure the resistance between the IAC valve terminals using an ohmmeter.
Specification
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harnesses for open or short (continuity check).
Open circuit
- IAC valve terminal A (harness-side) and PCM terminal 4G
- IAC valve terminal B (harness-side) and PCM terminal 4J
Short circuit
- IAC valve terminal A (harness-side) and power supply
- IAC valve terminal A (harness-side) and GND
- IAC valve terminal B (harness-side) and power supply
- IAC valve terminal B (harness-side) and GND
Mazda 6 Service Manual: Drive plate removal/installation
1. Remove the transaxle.(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the figure.
3. Install in the reverse order of removal.
Drive Plate Mounting Bolts Removal Note
1. Set the SST or equivalent against the drive plate.
2. Remove the bolts and the dri ...
Mazda 6 Service Manual: System Operation
Make sure that the Lane-keep Assist System (LAS) & Lane Departure Warning System
(LDWS) OFF indicator light in the instrument cluster is turned off. When the Lane-keep
Assist System (LAS) & Lane Departure Warning System (LDWS) OFF indicator light is
turned on, press the switch and make ...