Mazda 6 Service Manual: Variable intake-air system (vis) shutter valve actuator inspection (l3)
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
2. Disconnect the vacuum hose from the VIS shutter valve actuator.
3. Connect a vacuum pump to the VIS shutter valve actuator.
4. Apply vacuum and verify that the rod moves.
- If the rod dose not move, replace the intake manifold.
Idle air control (iac) valve inspection
Note
Perform the following inspection only when directed.
Operation Test
Carry out the Idle Air Control Inspection. (See Idle Air Control System
Inspection.)
If not as specified, perform ...
Variable intake-air system (vis) control solenoid valve inspection (l3)
1. Remove the VIS control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VIS ...
Other materials:
Mazda 6 Service Manual: Wheel alignment pre-inspection
1. Inspect the tire inflation, and adjust to the recommended pressure as
necessary.
2. Inspect the front wheel bearing play and correct it if necessary. (See
Wheel Bearing Play Inspection.)
3. Inspect the wheel and tire runouts. (See SUSPENSION.)
4. Inspect the ball joints and steering linkag ...
Mazda 6 Service Manual: Starting procedure for on-board diagnostic test mode
Note
All DTCs displayed in the on-board diagnostic test mode should be
entered in the Audio Repair Order Form.
1. Turn the ignition switch to the ACC or ON position.
2. First press the POWER button, then simultaneously press the AM button and
TAPE/MD button for 2 seconds or more.
N ...