Mazda 6 Service Manual: Inspection of sst (deployment tool)
- Use the SST
(Deployment tool) to deploy a live (undeployed) air bag module or pre-tensioner seat belt before disposing of it.
- Before using the SST
(Deployment tool), inspect its operation.
Inspection Procedure
Follow the steps below to verify that the SST
(Deployment tool) is operating correctly.
- If not as specified, do not use the SST
(Deployment tool) because it may cause the air bag module or pre-tensioner seat belt to unexpectedly deploy upon connection to the air bag module or pre-tensioner seat belt.
Air bag module and pre-tensioner seat belt disposal procedures
Warning
Before scrapping a vehicle with a live (undeployed) air bag module
and pre-tensioner seat belt, deploy the air bag module and pre-tensioner
seat belt. Never dispose of a live (undepl ...
Other materials:
Mazda 6 Service Manual: Purge solenoid valve removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Vacuum Hose Installation Note
Attach the vacuum hose onto the purge solenoid valve until it contacts the
stopper.
Evaporative Hose Installation Note
Attach ...
Mazda 6 Service Manual: Schedule 1
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
R: Replace
L: Lubricate
T: Tighten
Remarks:
*1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant
other than FL-22 may cause serious damage to the engine and cooli ...