Mazda 6 manuals

Mazda 6 Service Manual: Lower panel removal/installation

Mazda 6 Service Manual / Body / Dashboard and console / Lower panel removal/installation

1. Remove the bonnet release lever.

2. Remove the screws.

3. Pull the lower panel toward you, then disengage clips A and tabs B from the dashboard, and remove the lower panel.


4. Install in the reverse order of removal.

Meter hood removal/installation
1. Remove the screws. 2. Pull the meter hood toward you, then detach the column cover. 3. Install in the reverse order of removal. ...

Center box removal/installation
1. Disconnect the negative battery cable. 2. Remove the center panel module. 3. Remove the screws. 4. Pull the center box forward, then disengage the tabs 5. Disconnect the LDC unit connector. ...

Other materials:

Mazda 6 Service Manual: Inspection of dtcs for condition detection mode
Note The cruise set indicator light will illuminate for 3 seconds, when condition detection mode is on. If the RESUME/ACCEL switch on the cruise control switch is malfunctioning, the cruise set indicator light will not give a correct indication when you inspect the system. 1. Drive ...

Mazda 6 Service Manual: Headlight bulb removal/installation
Low-beam Halogen type 1. Disconnect the negative battery cable. 2. Disconnect the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. Caution A halogen bulb generates extremely high heat when it is used. If the ...

© 2016-2026 Copyright www.mazda6info.net