Mazda 6 Service Manual: No.1 insufficient air (or no air) blown from vents
Diagnostic Procedure
No.2 amount of air blown from vents does not change
Full-auto Air Conditioner
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor c ...
Other materials:
Mazda 6 Service Manual: Refrigerant system service procedures
GAS CHARGING SET INSTALLATION
1. Fully close the valves of the SST (49 C061 001).
2. Connect the SSTs (49 C061 002, 49 C061 003) to the high- and
low-pressure side joints of the SST (49 C061 001).
3. Connect the SSTs (49 C061 006A, 49 C061 007) to the ends of the
SSTs (49 C061 002, 49 C061 00 ...
Mazda 6 Service Manual: Rear shock absorber removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...