Mazda 6 manuals

Mazda 6 Service Manual: No.9 noise while operating a/c system


Diagnostic procedure



* : If there is gas leakage, air enters into the A/C system. The desiccant within the receiver/drier absorbs the moisture from the air and becomes saturated. If the A/C system is used in this condition, the inside of the A/C compressor will begin to rust due to this moisture, which may cause lock up or noise to occur. Therefore, replacement of the receiver/drier is necessary.

No.8 no cool air
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while performing the inspection to discover whether poor contact points are the cause o ...

Technical data
ENGINE LUBRICATION SYSTEM Note The maintenance intervals on scheduled maintenance table (See SCHEDULED MAINTENANCE TABLE) can only be supported by the use of following oils. Recomme ...

Other materials:

Mazda 6 Service Manual: No.1 air bag system warning light does not illuminate
Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connec ...

Mazda 6 Service Manual: Abs (abs/tcs) or dsc hu/cm configuration
1. Connect the WDS or equivalent to the DLC-2. 2. Input vehicle information following the direction on the WDS or equivalent screen. 3. Select Module programming. 4. Select Programmable module installation. 5. Select ABS/TCS. 6. Retrieve DTCs by the WDS or equivalent, then verify that there ...

© 2016-2026 Copyright www.mazda6info.net