Mazda 6 Service Manual: Radiator
RADIATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
3. Remove the cooling fan. (See COOLING FAN REMOVAL/INSTALLATION.)
4. Remove the oil hose. (ATX)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
8. Inspect the engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION.)
Radiator cap
Warning
Never remove the radiator cap while the engine is running, or when
the engine and radiator are hot. Scalding coolant and steam may shoot out
and cause serious injury. It may also dam ...
Thermostat
THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive bel ...
Other materials:
Mazda 6 Service Manual: Front door removal/installation
1. Disconnect the negative battery cable.
2. To remove the front door hinge, remove the front fender panel.
3. To remove the checker, remove the door speaker.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the front door. (See DOOR ADJUS ...
Mazda 6 Service Manual: Drive shaft removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...