Mazda 6 Owners Manual: Traffic Sign Display Indication
The following traffic signs are displayed on the active driving display.
Speed limit signs

Do not enter signs

Stop signs

The above indications are some examples.
NOTE
Speed limit signs
- When the vehicle speed is about 1 km/h (0.6 mph) or faster, the speed
limit sign is displayed when any one of the following conditions are met.
- The Forward Sensing Camera (FSC) recognizes a speed limit sign as
a sign targeted for your vehicle and the vehicle passes it.
- The speed limit sign stored in the navigation system is read (if
the Forward Sensing Camera (FSC) does not recognize a speed limit sign).
- In the following cases, display of the speed limit sign stops.
Do not enter signs
- A do not enter sign is displayed when all of the following conditions
are met.
- The vehicle speed is about 60 km/h (37 mph) or slower.
- The Forward Sensing Camera (FSC) recognizes a do not enter sign as
a sign targeted for your vehicle and the vehicle passes it.
- In the following case, the display of the do not enter sign stops.
- The Forward Sensing Camera (FSC) recognizes the do not enter sign
and a certain period of time has elapsed since the vehicle passed the sign.
Stop sign
- A stop sign is displayed when all of the following conditions are met:
- The vehicle speed is about 30 km/h (19 mph) or slower.
- The Forward Sensing Camera (FSC) recognizes a stop sign as a sign
targeted for your vehicle.
- In the following cases, display of the stop sign stops.
- A certain period of time has elapsed since the stop sign was displayed.
The Traffic Sign Recognition System (TSR) helps prevent the driver from overlooking
traffic signs, and provides support for safer driving by displaying traffic signs
on the active driving display ...
If the vehicle speed exceeds the speed limit sign displayed on the active driving
display, the warning sound is activated and the area around the speed limit sign
displayed on the active driving d ...
Other materials:
Mazda 6 Owners Manual: Variable air duct (vad) control solenoid valve inspection (l3)
1. Remove the VAD control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VAD control solenoid valve.
If as specified, carry out the Circuit Open/Short Inspection.
Circ ...
Mazda 6 Owners Manual: Steering angle sensor inspection
With DSC
1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
2. Disconnect the steering angle sensor connector.
3. Connect battery positive voltage to terminal A and ground to terminal F of
the steering angle sensor.
4. Turn the steering wheel to the right and left, and verify ...