Mazda 6 Service Manual: Troubleshooting index

Basic power window system inspection

Manual Mode Function Inspection Automatic Mode Function Inspection Automatic Window Return Function Inspection IG OFF Timer Function Inspection Two-step Down Function Inspection The ...

No. 1 driver-side front window does not go up and down in automatic mode

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Steering gear and linkage inspection
Rack Inspection 1. Inspect the rack for cracking, damage, and tooth wear. Replace it as necessary. 2. Measure the runout of the rack. Runout Near point A: 0.15 mm {0.006 in} max. Near point B: 0.20 mm {0.008 in} max. 3. If not within the specification, replace the rack. Tie-rod End ...

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...