Mazda 6 Service Manual: Drive belt

Mechanical location index

...

Drive belt inspection

Note Front and water pump drive belt deflection/tension inspection is not necessary because of the use of the front drive belt auto tensioner. Front Drive Belt Verify that the drive belt au ...

Other materials:

Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure conne ...

Mazda 6 Service Manual: Water pump
1. Disconnect the negative battery cable. 2. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) (See ENGINE COOLANT REPLACEMENT.) 3. Loosen the water pump pulley bolt to remove the drive belt. (See DRIVE BELT REPLACEMENT.) 4. Remove in the order indicated in the table. 5. Insta ...