1. Set the mode selector dial to the
position.
2. Set the air intake selector to the outside air position (indicator light turns off).
3. Set the temperature control dial to the hot position.
4. Set the fan control dial to the desired speed.
5. If dehumidified heating is desired, turn on the air conditioner.
NOTE
position.
position and adjust the
Control Switches
Cooling (With air conditioner)Mazda 6 Owners Manual: Indication/Indicator Lights
These lights turn on or flash to notify the user of the system operation status
or a system malfunction.
*Some models.
*1 The light turns on when the ignition is switched on for an operation check,
and turns off a few seconds later or when the engine is started. If the light does
not t ...
Mazda 6 Owners Manual: Water pump
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) (See
ENGINE COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the drive belt. (See DRIVE
BELT REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Insta ...