Mazda 6 Service Manual: Hold switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the console.
3. Disconnect the connector and remove the HOLD switch terminals. (See SELECTOR LEVER DISASSEMBLY/ASSEMBLY.)
4. Remove the selector lever knob component.
5. Remove the HOLD switch.
6. Install the HOLD switch to selector lever knob component.
7. Install selector lever knob component.
Tightening torque 15.68-22.54 N·m {1.599-2.298 kgf·m, 12-16 ft·lbf}
8. Install the HOLD switch terminals and connect the connector.
9. Install the console.
10. Connect the negative battery cable.
Hold switch inspection
Operating Inspection
1. Turn the ignition switch to ON (engine OFF).
2. Verify that the HOLD indicator light is not illuminated. Depress the HOLD
switch and verify that the HOLD indicator light il ...
Transaxle range (tr) switch inspection
Operating Inspection
1. Verify that the starter operates only when the ignition switch is at the
START position with the selector lever in P or N position.
If not as specified, adjust the TR sw ...
Other materials:
Mazda 6 Service Manual: Active Adaptive Shift (AAS)
Active Adaptive Shift (AAS) automatically controls the transaxle shift points
to best suit the road conditions and driver input. This improves driving feel. The
transaxle may switch to AAS mode when driving up and down slopes, cornering, driving
at high elevations, or depressing the accelerato ...
Mazda 6 Service Manual: Operating Tips for AAC
AAC stands for Advanced Audio Coding, which is standardized voice compression
established by the ISO*1 working group (MPEG). Audio data can be created and stored
at a higher compression ratio than MP3.
This unit plays files with the extensions (.aac/.m4a/.wav) as the AAC files.
*1 Internationa ...