Mazda 6 manuals

Mazda 6 Owners Manual: Washer Fluid

Inspecting Washer Fluid Level

WARNING

Use only windshield washer fluid or plain water in the reservoir:

Using radiator antifreeze as washer fluid is dangerous. If sprayed on the windshield, it will dirty the windshield, affect your visibility, and could result in an accident.

Using Washer Fluid Without Anti-freeze Protection in Cold Weather:

Operating your vehicle in temperatures below 4 degrees C (40 degrees F) using washer fluid without anti-freeze protection is dangerous as it could cause impaired windshield vision and result in an accident. In cold weather, always use washer fluid with antifreeze protection.

NOTE

State or local regulations may restrict the use of volatile organic compounds (VOCs), which are commonly used as anti-freeze agents in washer fluid. A washer fluid with limited VOC content should be used only if it provides adequate freeze resistance for all regions and climates in which the vehicle will be operated.

Inspect fluid level in the washer fluid reservoir; add fluid if necessary.


Use plain water if washer fluid is unavailable.

But use only washer fluid in cold weather to prevent it from freezing.

Brake/Clutch Fluid
Inspecting Brake/Clutch Fluid Level WARNING If the brake/clutch fluid level is low, have the brakes inspected: A low brake/clutch fluid level is dangerous. A low level could indicate brake lining ...

Body Lubrication
All moving points of the body, such as door and hood hinges and locks, should be lubricated each time the engine oil is changed. Use a nonfreezing lubricant on locks during cold weather. Make sur ...

Other materials:

Mazda 6 Owners Manual: Warning Indication/Warning Lights
These lights turn on or flash to notify the user of the system operation status or a system malfunction. *1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remai ...

Mazda 6 Owners Manual: Steering angle sensor inspection
With DSC 1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION) 2. Disconnect the steering angle sensor connector. 3. Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor. 4. Turn the steering wheel to the right and left, and verify ...

© 2016-2026 Copyright www.mazda6info.net