1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Socket Removal Note
1. Insert a tape-wrapped screwdriver into the socket hole, then press against the ring protrusion to lift the socket toward you.
2. As shown in the figure, lift out the socket until the ring protrusion locks into the lower socket hole.
3. Remove the boot panel.
4. From behind the boot panel, slide a tape-wrapped screwdriver in between the socket and the ring protrusion.
5. While twisting the ring protrusion with the screwdriver, push out and remove the socket.
Ring Removal Note
Pull the ring forward while compressing the hooks.
Mazda 6 Service Manual: Oil pressure inspection
Warning
Continuous exposure to USED engine oil has caused skin cancer in
laboratory mice. Protect your skin by washing with soap and water
immediately after working with engine oil.
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine ...
Mazda 6 Service Manual: Instrument cluster inspection
Speedometer
Using the input/output check mode
Inspect the speedometer by setting it in the input/output check mode DTC 12.
Using a speedometer tester
1. Adjust the tire air pressure to the specification.
2. Using a speedometer tester, verify that the speedometer indication is
within the allow ...