Mazda 6 Owners Manual
Mazda 6 Owners Manual
- Pictorial Index
- Essential Safety Equipment
- Before Driving
- Keys
- Advanced Keyless Entry System
- Doors and Locks
- Fuel and Emission
- Steering Wheel
- Mirrors
- Windows
- Security System
- Driving Tips
- Towing
- When Driving
- Start/Stop Engine
- Instrument Cluster and Display
- Manual Transaxle Operation
- Automatic Transaxle
- Switches and Controls
- Brake
- ABS/TCS/DSC
- i-ELOOP
- Fuel Economy Monitor
- Drive Selection (Some models)
- Power Steering
- i-ACTIVSENSE
- Cruise Control (Some models)
- Tire Pressure Monitoring System
- Rear View Monitor
- Interior Features
- Maintenance and Care
- If Trouble Arises
- Parking in an Emergency
- Flat Tire
- Battery Runs Out
- Emergency Starting
- Overheating
- Emergency Towing
- Warning/Indicator Lights and Warning Sounds
- When Trunk Lid Cannot be Opened
- Active Driving Display Does Not Operate
- Customer Information and Reporting Safety Defects
- Customer Assistance
- Mazda Importer/Distributors
- Reporting Safety Defects
- Warranty
- Cell Phones
- Event Data Recorder
- Recording of Vehicle Data
- Uniform Tire Quality Grading System (UTQGS)
- Tire Information (U.S.A.)
- Declaration of Conformity
- Specifications
Pictorial Index
Interior, exterior views and part identification of your Mazda. ...
Other materials:
: Dsc hu/cm inspection
1. Remove the battery and battery bracket.
2. Disconnect the DSC HU/CM connector.
3. Connect the SST (49 G066 004) to the DSC HU/CM connector and
harness side connector.
4. Inspect voltage referring the table below.
Terminal Voltage Table (reference value)
(Ignition switch is at ON, and conne ...
: Pcm removal/installation
Note
For replace the PCM, Setup the WDS and perform the PCM
configuration. (See PCM CONFIGURATION.)
1. Disconnect the negative battery cable.
2. For R.H.D, perform the following procedures.
(1) Remove the front side trim (left-side).
(2) Partially peel back the flower covering.
3 ...
© 2016-2026 Copyright www.mazda6info.net