Diagnostic procedure
Mazda 6 Service Manual: Engine control system operation inspection
Main Relay Operation Inspection
Verify that the main relay clicks when the ignition switch is turned to ON
position and off.
If there is no operation sound, inspect the following.
- Main relay (See RELAY INSPECTION.)
- Harness and connector between ignition switch and main relay termi ...
Mazda 6 Service Manual: Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along
the direction (1) shown in the figu ...