Mazda 6 Service Manual: Electrical parts
Battery cable
- Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable.
Wiring Harness
- To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver.
Connectors
Data link connector
Insert the probe into the terminal when connecting a jumper wire to the
data link connector.
Caution
Inserting a jumper wire probe into the data link connector
ter ...
Other materials:
Mazda 6 Service Manual: Refrigerant pressure switch removal/installation
1. Remove the battery.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Loosen the refrigerant pressure switch using two spanners.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
Refrigerant Pressure Switch Installat ...
Mazda 6 Service Manual: Input/turbine speed sensor removal/installation
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner component. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
4. Disconnect the input/turbine speed sensor connector.
5. Remove the input/turbine speed sensor.
6. Apply ATF to a new O-ring ...