Mazda 6 Service Manual: Exterior lighting system

Power system

Interior lighting system

Other materials:

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Service Manual: Evaporator temperature sensor inspection
1. Turn the AUTO switch on. 2. Set the temperature control at MAX COLD (Turn the left). 3. Turn the A/C switch. 4. Set the RECIRCULATE mode. 5. Close all doors and windows. 6. Wait for 5 minutes. 7. Remove the glove compartment. 8. Disconnect the evaporator temperature sensor. 9. Measure t ...