Mazda 6 Service Manual: Front combination light removal/installation
Caution
- Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing the discharge headlights, always refer to the Discharge headlight service warnings. (See DISCHARGE HEADLIGHT SERVICE WARNINGS)
Note
- When the ignition switch is turned to ON, it is normal to hear the headlight leveling actuator operating for a few second, as it verifies headlight auto leveling system operating condition.
1. Disconnect the negative battery cable.
2. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the headlight aiming. (See HEADLIGHT AIMING.)
Discharge headlight service warnings
Discharge headlight bulb service warnings
To prevent electrical shock when replacing the discharge headlight bulb,
dry hands thoroughly, and carry out work in an area out of rain.
When the li ...
Headlight aiming
Low-beam
1. Set up a screen as shown in the figure below for aiming the headlights.
2. Adjust the tire air pressure to the specification.
3. Position the unloaded vehicle on a flat, level surfa ...
Other materials:
Mazda 6 Service Manual: Road test
Warning
When performing a road test, be aware of other vehicles, people,
impediments, etc. to avoid an accident.
Note
When the legal speed limit must be exceeded, use a chassis
dynamomenter instead of performing a road test.
Road Test Preparation
1. Inspect the engine coolant le ...
Mazda 6 Service Manual: Refrigerant lines removal/installation
1. Remove the battery.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Remove the washer tank. (L.H.D. only) (See WASHER TANK
REMOVAL/INSTALLATION.)
4. Remove the air cleaner cover, air cleaner element and air cleaner case.
(See INTAKE-AIR SYSTEM
REMOVAL/INST ...