Mazda 6 Service Manual: Front lower arm (rear) inspection
1. Remove the lower arm (rear) from the vehicle.
2. Inspect for damage, cracks, and bending.
3. Inspect the ball joint rotation torque.
(1) Rotate the ball joint five times.
(2) Measure the rotation torque using a suitable allen socket and a torque wrench.
- If not within the specification, replace the lower arm component.
Rotation torque
1.00-2.22 N·m
{10.2-22.6 kgf·cm, 8.86-19.6 in·lbf}
Front lower arm (rear) removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the ...
Front stabilizer removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the h ...
Other materials:
Mazda 6 Service Manual: Dsc on-board diagnosis
On-Board Diagnostic (OBD) Test Description
(See ABS (ABS/TCS) ON-BOARD DIAGNOSIS)
DTC Table
PID/DATA Monitor Table
Active Command Modes Table
...
Mazda 6 Service Manual: Neutral switch inspection
Note
Perform the following inspection only when directed.
Continuity Inspection
1. Disconnect the negative battery cable.
2. Remove the neutral switch.J5 MANUAL TRANSAXLE REMOVAL/INSTALLATION.)
3. Inspect for continuity between the neutral switch terminals using an
ohmmeter.
If the n ...