PRECAUTION (CLUTCH)
Clutch Pipe Removal/Installation
Note
1. If clutch pipes have been disconnected any time during the procedure, add clutch fluid (brake fluid), bleed the air, and inspect for leakage after the procedure has been completed.
2. Remove the clutch pipe using the SST
(49 0259 770B). Install the clutch pipe using torque wrench SST
combination. (See TORQUE FORMULAS.)
Mazda 6 Service Manual: Panel light control switch inspection
1. Connect the connector to the panel light control switch.
2. Connect the negative battery cable.
3. Measure the voltage at the panel light control switch using voltmeter.
When inspecting terminal B for continuity, disconnect the panel light
control switch connector.
4. If the value are ...
Mazda 6 Service Manual: Transmitter battery replacement
1. Insert a small screwdriver into the slot and gently pry open the
transmitter.
2. Press the portion of the battery indicated by A and remove the battery.
3. Install a new battery (CR2025) into the front portion of the holder with
the positive pole (+) facing up. Press on the B portion of ...