PRECAUTION (FRONT AND REAR AXLE)
Wheel and Tire Removal/Installation
1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}
Brake Line Disconnection/Connection
Caution
1. Tighten the brake pipe flare nut using the SST
(49 0259 770B). Be sure to modify the brake pipe flare nut tightening torque to allow for use of a torque wrench-SST
combination. (See TORQUE FORMULAS.)
2. If any brake line has been disconnected any time during the procedure, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.
Suspension Arm Removal/Installation
1. Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered and unloaded.
Note
Mazda 6 Service Manual: Engine Coolant Temperature Gauge (Without Multi-information Display)
Displays the engine coolant temperature. The white gauge indicates that the engine
coolant temperature is low, and the red gauge indicates that the engine coolant
temperature is high and overheating.
CAUTION
If the engine coolant temperature gauge indicator flashes, there is a possibility
...
Mazda 6 Service Manual: Engine oil replacement
Warning
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil has cooled.
A vehicle that is lifted but not securely supported on safety
stands is dangerous. It can slip or fall, causing death or serious injury.
Never work around or ...